Siemens SIMATIC FM 353 Manual page 332

Troubleshooting
Table 11-8 General data errors, machine data errors, traversing program errors, continued
Cl. No.
Traversing program errors
8 (08) 11 (0B) Program selection, direction specification incorrect
Cause
Effect
Elimination
8 (08) 12 (0C) Program selection unacceptable
Cause
Effect
Elimination
8 (08) 20 (14) Error, program number
Cause
Effect
Elimination
8 (08) 21 (15) No block in program
Cause
Effect
Elimination
8 (08) 22 (16) Error, block number
Cause
Effect
Elimination
8 (08) 23 (17) Block number sequence incorrect
Cause
Effect
Elimination
8 (08) 24 (18) G function 1 unacceptable
Cause
Effect
Elimination
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
11-30
Error message,
error analysis and remedy
Error response: "Warning" see Table 11-2
Direction specification incorrect
Program selection is not executed
Correct program selection and repeat.
Another program was preselected during a movement
Program selection is not executed
Use STOP to stop program in progress, or repeat program
selection at end of program.
Program numbers in the blocks incorrect
Program is not stored
Correct program, per cause
No block in program
Program is not stored
Correct program, per cause
Block number value range incorrect
Program is not stored
Correct program
Block number not in ascending order
Program is not stored
Correct program
S
The number programmed as G function 1 is not allowed.
S
In block, other data besides M functions were pro-
grammed with dwell time (G04).
Program/block not stored
Correct program, per cause
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Mes-
sage/
Display
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB