Error List, System Messages (Cpu) - Siemens SIMATIC FM 353 Manual

Programming the Technological Functions
6.8

Error list, system messages (CPU)

The Table below lists some of the errors which occur during data transfer with the
internal SFC/SFBs (RET_VAL in SFCs 51, 58 and 59 and status messages (bytes
2 and 3), SFB 52/53, system messages) (see Reference Manual System Software
for S7-300/400; System and Standard Functions).
Table 6-12 Error list
Error Code (AW-DB, DBW66)
HEX DEC
0 0 0
8082 32898 −32638
8085 32901 −32635
80A0 32928 −32608
80A1 32929 −32607
80A2 32930 −32606
80A3 32931 −32605
80A4 32932 −32604
80A7 32935 −63601
80A9 32937 −63599
80AA 32938 −32598
to to to
80AF 32943 −32593
80B0 32944 −32592
80B1 32945 −32591
80B2 32946 −32590
80B3 32947 −32589
80B5 32949 −32587
80B6 32950 −32586
80C0 32960 −32576
80C1 32961 −32575
80C2 32962 −32574
80C3 32963 −32573
6-64
INT
No errors
SZL_ID invalid or not in CPU
Information currently unavailable (caused by system)
Negative acknowledgement when reading from module. Module re-
moved during Read operation or module defective.
Negative acknowledgement while writing to module. Module removed
during Write operation or module defective.
DP protocol error in layer 2 (data transfer over Profibus-DP interrupted,
e.g. due to wirebreak, missing terminator, parameterization error, etc.)
S
PROFIBUS: DP protocol error in layer 2 (data transfer over Profi-
bus-DP interrupted, e.g. due to wirebreak, missing terminator,
parameterization error, etc.)
S
PROFINET IO: General CM error
Communication problem on K bus
DP slave or module is busy
This function is not supported by DP slave or by the module.
DP slave or module is reporting a manufacturer−specific error in the
evaluation. For specifying the error, please refer to the Manufacturer
Documentation of the DP slave or of the module.
The module does not know this data record.
Invalid length specification in the RECORD parameter
The configured slot is not occupied.
Actual module type not the same as setpoint module type
DP slave or module not ready
Access to DP slave or module denied
Module does not yet have the data to be read available
Data from an identical Write job have not yet been processed on the
module
Module is currently servicing the maximum possible number of re-
quests
Needed resources (such as memory, etc.) are currently in use
Description
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0