Siemens SIMATIC FM 353 Manual page 35

Note
The device is designed for operation with safety extra−low voltage (SELV). This
means that only safety extra−low voltages (SELV) complying with
IEC950/EN60950/VDE0805 may be connected to the power supply terminals.
The power unit for supplying the device must comply with NEC Class 2 as de-
scribed by the National Electrical Code(r) (ANSI/NFPA 70).
The power of all connected power units in total must correspond to a limited power
source (LPS).
Connecting cables
Table 4-1 lists the connecting cables for a positioning controller with the FM 353.
Table 4-1
Type
MPI connecting
cable
Setpoint cable
Front connector
You need a 20-pin screw-type front connector for wiring the digital I/Os. It must be
ordered separately.
Order No.:
see Catalog ST 70, Order No. E86060-K4670-A101-A
see Catalog NC 60.1, Order No. E86060-K4460-A101-A
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Connecting cables for a positioning controller with FM 353
Order No.
see Catalog ST 70, Order No.
E86060-K4670-A101-AV
6FX2 002-3AC02-1VV0
see Catalog NC Z
Order No.: E86060-K4490-A001-AV
6ES7 392-1AJ00-0AA0
Description
Connection between OP,
PG and S7-300 CPU
Connection between
FM 353 and stepper drive
V
V
Wiring
4-3