Siemens SIMATIC FM 353 Manual page 322

Troubleshooting
Table 11-7 Travel errors, continued
Cl. No.
Travel errors
3 (03) 68 (44) Boost duration relative exceeded
Cause
Effect
Elimination
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
Table 11-8 General data errors, machine data errors, traversing program errors
Cl. No.
General data errors
4 (04) 1 (01) Data at time of transmission unacceptable
Cause
Effect
Elimination
4 (04) 2 (02) Velocity level 1 incorrect
Cause
Effect
Elimination
4 (04) 3 (03) Velocity level 2 incorrect
Cause
Effect
Elimination
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
11-20
Error message,
error analysis and remedy
Error response: "Feed STOP" see Table 11-2
Acceleration phases too high in component compared with
idle/constant travel
S
Check MD49
S
Change drive configuration
S
Change technology (axis traversing cycle)
Error message,
error analysis and remedy
Error response: "Warning" see Table 11-2
Data not transmitted in appropriate operating mode
Data not accepted
Transmit data in appropriate operating mode
Velocity not within the range between > 0 and max. allow-
able traverse velocity (500 000 000 MSR/min)
Velocity does not become effective
Input an allowed velocity value
Velocity not within the range between > 0 and max. allow-
able traverse velocity (500 000 000 MSR/min)
Velocity does not become effective
Input an allowed velocity value
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Mes-
sage/
Display
CBS
Mes-
sage/
Display
CBS
or
DB DB
CBS
or
DB
CBS
or
DB