Siemens SIMATIC FM 353 Manual page 329

Table 11-8 General data errors, machine data errors, traversing program errors, continued
Cl. No.
Machine data errors
5 (05) 32 (20) Type of output, M-function
Cause
Effect
Elimination
5 (05) 33 (21) Output time, M-function
Cause
Effect
Elimination
5 (05) 34 (22) Digital inputs
Cause
Effect
Elimination
5 (05) 35 (23) Digital outputs
Cause
Effect
Elimination
5 (05) 36 (24) Input adapter
Cause
Effect
Elimination
5 (05) 52 (34) Velocity for backlash compensation
53 (35) Backlash compensation mode
Cause
Effect
Elimination
5 (05) 67(43) Special control signals
68 (44) Number of increments per current-sourcing cycle
Cause
Effect
Elimination
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Error message,
error analysis and remedy
Error response: "Warning" see Table 11-2
Type of output, M-function not defined
DB does not become effective and is stored non-retentively
Correct and retransmit
Unacceptable value range
DB does not become effective and is stored non-retentively
Correct and retransmit
Inputs undefined or defined more than once
DB does not become effective and is stored non-retentively
Correct and retransmit
Outputs undefined or defined more than once
DB does not become effective and is stored non-retentively
Correct and retransmit
Input adapter undefined
DB does not become effective and is stored non-retentively
Correct and retransmit
Impermissible value range or dependency violation
(see Section 5.3.1).
DB does not become effective and is stored non-retentively.
Correct and retransmit.
Impermissible value range or dependency violation on no.
68 (see Section 5.3.1)
DB does not become effective and is stored non-retentively
Correct and retransmit
Troubleshooting
Mes-
sage/
Display
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or or
DB
CBS
or or
DB
11-27