Siemens SIMATIC FM 353 Manual page 55

5.1 Installing "Parameterize FM 353"
Prerequisites
One of the following operating systems must be installed on the programming de-
vice (PG/PC):
S Windows 2000
S Windows 2003 Server
S Windows XP
You need the STEP 7 program (V5.3 +SP2 or higher)
For online operation, make sure that your programming device (PG) / PC is
connected to the S7-300 CPU (see Figure 4-1). For distributed use of the FM, a
connection from the PG / PC must be established to the L2 DP network. For
distributed use of the FM 353 in PROFINET, a connection from the PG / PC must
be established to the L2 DP network or to the Ethernet via a switch module.
Installation
The entire software (parameterization tool, function blocks and preconfigured user
interface for OPs) is stored on CD ROM.
Install the software as follows:
1. Insert the CD ROM in the CD ROM drive of your PG/PC.
2. Run file Setup.exe on the CD ROM.
3. Follow the instructions displayed by the installation routine step for step.
Result: The software is installed in the following directories:
− "Parameterize FM 353" parameterization tool: [STEP7 directory]\S7FSTEP
− Technology functions:
[STEP7 directory]\S7LIBS\FMSTSV_L (library name: "FMSTSV_L")
− Technology functions (also for PROFINET, upon request):
[STEP7 directory]\S7LIBS\FM353_354 (library name: "FM353_354")
− User interface for OPs:
[STEP7 directory]\EXAMPLES\FM353\zDt13_02_FM353_OP_EX
− Sample applications for blocks of the FMSTSV_L library:
[STEP7 directory]\EXAMPLES\zDt13_02
STEP7 project name: zDt13_02_FM353_EX
− Sample applications for blocks of the FM353_354 library:
[STEP7 directory]\EXAMPLES\zDt13_03
STEP7 project name: zDt13_03_FM353_EX
− MD DBs (for commissioning of the stepper drive):
[STEP7 directory]\EXAMPLES\FM353\MD
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Defining Parameters
5-3