iDect FC6A series User Manual page 99

Terminal Arrangement and Wiring Examples
When connecting the terminal, insert an IEC 60127-approved fuse suitable for the applied voltage and current draw at
•
Caution
the position shown in the following diagram.
(Applicable when equipment containing the FC6A Series MicroSmart is destined for Europe)
Do not connect a thermocouple to a part with hazardous voltage (60V DC or peak 42.4V DC or higher part).
•
Before turning on the power, always check the wiring. If wiring is incorrect, the analog I/O module may be damaged.
•
■ FC6A-J2C1
Terminal block type
ANALOG
PWR
FC6A-J2C1
Applicable Connector: FC6A-PMTB11PN02 (screw fastened type),
For wiring precautions, see "Input/Output Wiring" on page 3-15.
: Fuse
- +
Analog Voltage/
current Output Device
- +
2-wire Analog Output Sensor
FC6A S M S A
ERIES ICRO MART
FC6A-PMSB11PN02 (spring clamp type)
Terminal No. I/O
24V
0V 24V DC
FG
NC NC
NC NC
+
I0+
IN0
-
I0-
NC NC
I1+
IN1
I1-
NC NC
- -O T U ' M
LL IN NE YPE SER S ANUAL
2: P S
RODUCT PECIFICATIONS
FC9Y-B1722 2-71