iDect FC6A series User Manual page 35

(16) CAN Ports
These ports allow J1939 communication.
(17) Ethernet Port 1
This port allows Ethernet communication with connected devices that are equipped with an Ethernet interface.
(18) ACT LED
This LED flashes when sending or receiving data while the LINK LED is on.
(19) LINK LED
This LED is on when a network-compatible device is connected to Ethernet Port 1.
(20) Power Supply Terminals
These terminals are used to supply power to the CPU module.
The AC power type uses an AC power supply (100 to 240 V).
The DC power type is available as the 24V DC power type and the 12V DC power type.
(21) USB Port
A mini-B type USB 2.0 connector. A USB cable can be attached to the FC6A Series MicroSmart and connected to a PC to
download and upload user programs using WindLDR.
(22) SD Memory Card Slot
This slot is for inserting the SD memory card. This slot is for inserting the SD memory card. The SD memory card allows for
data logs using the DLOG/TRACE instructions, reading and writing device data, downloads from the SD memory card (user
program, system software, web page), and uploads to the SD memory card.
(23) Communication connector
This connector is used to connect the HMI module.
(24) Function Switch
This switch turns M8073 on or off (default setting: 0 (off)).
You can run or stop the CPU module with this switch by enabling Run/Stop PLC by Function Switch in WindLDR (default
setting: enabled).
For details on the function switch, see Chapter 5 "Function Switch Configuration" on page 5-9.
(25) SD Memory Card Cover
An openable cover that protects the SD memory card and function switch. Open the SD memory card cover when inserting
or ejecting the SD memory card and when using the function switch.
(26) Dummy Cartridges
Removable dummy cartridges that protect the cartridge slots. Remove the dummy cartridge when connecting an analog
cartridge or communication cartridge.
(27) Expansion Connector Protection Sticker
This sticker protects the expansion connector. Remove the expansion connector protection sticker when connecting an
expansion module.
(28) Ethernet Port 1 Cover
A removable cover that protects Ethernet Port 1. When using the Ethernet port, remove the Ethernet Port 1 cover.
(29) Power Supply Terminals Cover
An openable cover that protects the power supply terminals. Open the power supply terminals cover when removing and
attaching the power supply terminals.
(30) USB Port Cover
An openable cover that protects the USB port. When using the USB port, open the USB port cover.
(31) Communication Connector Protection Sticker
This sticker protects the communication connector. Remove the communication connector protection sticker when
connecting the HMI module.
FC6A S M S A
ERIES ICRO MART
- -O T U ' M
LL IN NE YPE SER S ANUAL
2: P S
RODUCT PECIFICATIONS
FC9Y-B1722 2-7