iDect FC6A series User Manual page 443

Troubleshooting Diagram 11
Data is not transmitted correctly
in the user communication mode.
parameters set correctly
designated as transmit
status used repeatedly?
more than 5 TXD instructions on
Is duration of the busy
signal at the remote terminal
sure of source 1 device of the TXD
Call IDEC for assistance.
*1 See Chapter 5 "Programming WindLDR" on page 5-25 in the "FC6A Series MicroSmart All-in-One Type Communication Manual".
If the user communication still has a problem after completing the above procedure, also perform the
procedure of Diagram 10, described on the preceding page.
Are communication
using WindLDR?
YES
Is the data register
NO
Are inputs to
simultaneously?
NO
less than 5 s?
YES
Did you make
instruction?
YES
FC6A S M S
ERIES ICRO MART
NO
Set the communication parameters to match those of
the remote terminal using WindLDR
YES
Correct the program to replace the duplicate data
register with a different data register.
Correct the program to make sure that inputs to
YES
more than 5 TXD instructions do not go on
simultaneously.
NO
Make sure that the busy signal at the remote
terminal does not exceed 5 s.
NO
Make sure that the transmit data designated as
source 1 device is correct.
A - -O T U ' M
LL IN NE YPE SER S
13: T
*1
.
FC9Y-B1722
ANUAL
ROUBLESHOOTING
13-17