iDect FC6A series User Manual page 301

Notes:
When the slave number is modified from the system menu, the value in the slave number type (constant/special data register) configured
•
with WindLDR is modified. The slave number type cannot be changed from the system menu.
If the slave number type configured with WindLDR is Constant, when the slave number is modified from the system menu and the
•
button is pressed, the modified slave number is reflected in the function area settings for the user program. If Special Data Register, the
values of D8100, D8102 and D8103 are modified. (The modification is not reflected in the function area settings for the user program.)
The values of D8100, D8102 and D8103 return to the default values when the battery backup dies.
•
The slave number range differs according to the communication mode (maintenance communication/Modbus RTU slave/Modbus TCP slave).
•
If a value outside the configuration range is set, the following message is displayed. Press the
the configuration screen, and then set the correct slave number again.
Port 2:
Out of valid range
0
For maintenance communication, see Chapter 4 "Maintenance Communication via Port 1" in the "FC6A Series MicroSmart All-in-One Type
•
Communication Manual". For Modbus RTU slave/Modbus TCP slave, see Chapter 6 "Modbus RTU Communication via RS232C/RS485" in the
"FC6A Series MicroSmart All-in-One Type Communication Manual".
Configuring the Network Settings
The CPU module and HMI module network settings can be configured. These settings are configured when the user program is stopped.
These cannot be configured while the user program is running.
Changing the CPU module network settings
■ Changing the setting
On the standard screen, press the
1.
Stopped
2015/DEC/01/TUE
13:30:40
The system menu is displayed.
Select Configurations with the
2.
Run
Edit Program
External Memory
Configurations
Select Function with the
3.
Function
Clock
Menu Languages
Backlight
Select Communications with the
4.
Communications
Message Settings
5. Select CPU Network Settings with the
Slave Number
CPU Network Settings
HMI Network Settings
The network settings screen is displayed.
(ESC) + (OK) buttons.
(up) and (down) buttons and press the
(up) and (down) buttons and press the
(up) and (down) buttons and press the
(up) and
FC6A S M S A
ERIES ICRO MART
(OK) button.
(down) buttons and press the
- -O T U ' M
LL IN NE YPE SER S ANUAL
7: HMI F
(ESC) button or the
(OK) button.
(OK) button.
(OK) button.
FC9Y-B1722
UNCTION
button to return to
7-15