iDect FC6A series User Manual page 135

Assembling the CPU Module and the HMI Module
The following procedure describes the assembly of the CPU module and the HMI module.
Peel off the protection sticker applied to the communication connector on the All-in-One Type.
1.
Communication Connector Protection Sticker
Line up the HMI module alongside the CPU module.
2.
Note: The CPU module and the HMI module are easier to line up if you use the position of the communication connector as a guide.
3. Confirm that the HMI module eject button is depressed and push the HMI module until it clicks while taking care with the
position of the communication connector. If the eject button is not depressed, push in the eject button until it clicks after the
HMI module has been pushed onto the CPU module.
The HMI module is now locked on the CPU module.
Do not perform this work when the FC6A Series MicroSmart is powered. Otherwise there is a risk of damage.
Caution
Communication Connector
Eject Button
FC6A S M S A
ERIES ICRO MART
- -O T U ' M
LL IN NE YPE SER S ANUAL
3: I
NSTALLATION AND
FC9Y-B1722
W
IRING
3-5