iDect FC6A series User Manual page 151

Removing and Attaching the Serial Port 1 Cover
The following procedure describes how to remove and attach the serial port 1 cover.
Removing the Serial Port 1 Cover
1. Insert a flathead screwdriver into the screwdriver slot on the serial port 1 cover and slowly move the screwdriver in the
direction of the arrow to unlock the bottom lock.
Serial Port 1 Cover
Screwdriver Slot
Lift the serial port 1 cover straight up in the direction of the arrow to remove it.
2.
Attaching the Serial Port 1 Cover
When not using serial port 1, attach the serial port 1 cover.
Insert the serial port 1 cover tabs into the grooves on the left and right sides of serial port 1 and push the cover straight in to
1.
attach it.
Tab
Serial Port 1 Groove
Note: Take care with the orientation of the serial port 1 cover. The groove to insert the screwdriver goes on the bottom.
Screwdriver Slot Groove
FC6A S M S A
ERIES ICRO MART
- -O T U ' M
LL IN NE YPE SER S ANUAL
3: I
NSTALLATION AND
FC9Y-B1722
W
IRING
3-21