iDect FC6A series User Manual page 349

Analog Output Type
The following parameters are for configuring the analog outputs on the analog output modules and the mixed analog I/O modules.
Yes: Parameters, ―: No parameters
No. Parameter
(1) Signal Type
(2) Data Type
Minimum and maximum values
(3)
(Data type)
(4) Data
(5) Status
(1) Signal Type
The signal type that can be set differs according to the analog module model. Select the analog module that corresponds to the
user application and set the signal type. There are five types of signal types for the analog outputs, which are detailed as
follows.
Yes: Supported, -: Not supported
Signal Type
*1
Unused
0 to 10 V
-10 to +10 V
0 to 20 mA
4 to 20 mA
*1 Channels that are set to unused are not scanned.
The circuit is setup the same as when signal type: 0 to 10 V is selected.
A channel set to unused always outputs 0 V.
The device connected to the analog module may be damaged if the analog output signal type is mistakenly set and used.
Caution
Please use caution when setting the analog output signal type.
FC6A-K4A1
Yes
Yes
Yes
Yes
Yes
(1)
FC6A-K4A1
Yes
Yes
Yes
Yes
Yes
FC6A S M S A
ERIES ICRO MART
FC6A-L06A1
(2) (3)
FC6A-L06A1
Yes
Yes
Yes
Yes
Yes
- -O T U ' M
LL IN NE YPE SER S ANUAL
9: F
UNCTIONAL
FC6A-L03CN1
Yes
Yes
Yes
Yes
Yes
(4) (5)
FC6A-L03CN1
FC9Y-B1722
M
ODULES
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
9-9