iDect FC6A series User Manual page 377

■ Read Recipe
FC6A Series MicroSmart device values can be read and saved to the SD memory card as a recipe file according to the FC6A Series
MicroSmart recipe settings. Reading starts when the bit of the set device is turned on. The device that serves as the condition to
start this reading is called the read trigger device.
The file is overwritten when there is already a recipe file with the same name.
SD Memory Card
Note: When read recipe is executed, a recipe file with the same name on the SD memory card is overwritten. Use caution not to execute a read
using the recipe file for writing the initial values.
■ Auto Write
This function writes recipe values for the specified block numbers at specific times. The write timing can be set as a combination of
the following four times.
When the FC6A Series MicroSmart power is turned on
•
When a user program is downloaded to the FC6A Series MicroSmart
•
When FC6A Series MicroSmart operation starts
•
When the keep data error occurs
•
A range of block numbers can be specified and all of the channels in the specified block numbers are applicable.
Recipe Execution and FC6A Series MicroSmart Status
Read and write recipe can be executed when the FC6A Series MicroSmart is running or stopped.
•
If the FC6A Series MicroSmart is stopped while reading or writing the recipe, reading or writing the recipe continues after stopping.
•
If the FC6A Series MicroSmart is set to run while reading or writing the recipe, the FC6A Series MicroSmart automatically runs after reading
•
or writing the recipe has finished.
Read and write recipe operate in user program END processing regardless of whether the FC6A Series MicroSmart is running or stopped.
•
FC6A Series MicroSmart
Recipe File
100,
150,
200,
Saves read device values
to the SD memory card
as a recipe file
FC6A S M S A
ERIES ICRO MART
Read Trigger Device
OFF
D0000=
D0001=
D0002=
- -O T U ' M
LL IN NE YPE SER S ANUAL
11: SD M
ON
Start reading
100
150
200
FC9Y-B1722
C
EMORY ARD
11-9