iDect FC6A series User Manual page 300

7: HMI F
UNCTION
Configuring the Slave Number
The slave number used in maintenance communication and Modbus RTU communication can be configured.
These settings can be configured when the user program is stopped. This cannot be configured while the user program is running.
On the standard screen, press the
1.
Stopped
2015/DEC/01/TUE
13:30:40
The system menu is displayed.
Select Configurations with the
2.
Run
Edit Program
External Memory
Configurations
Select Function with the
3.
Function
Clock
Menu Languages
Backlight
4. Select Communications with the
Communications
Message Settings
Select Slave Number with the
5.
Slave Number
CPU Network Settings
HMI Network Settings
The port selection screen is displayed.
Select Port 2 with the
6.
For example, change the slave number of the port 2 to 1.
Port 2:
0
Specify 1 with the
7.
Port 2:
1
to confirm
Port 2:
1
You can set the slave number of port 2 to 1.
Selectable slave numbers
•
The slave numbers that can be selected are as follows.
Port 1: 0 to 255
•
Port 2: 0 to 255
•
Port 3: 0 to 255
•
7-14
(ESC) +
(up) and
(up) and (down) buttons and press the
(up) and
(up) and
(up) and (down) buttons and press the
(up) and (down) buttons and press the
FC6A S M S
ERIES ICRO MART
(OK) buttons.
(down) buttons and press the
(down) buttons and press the
(down) buttons and press the
(OK) button.
(OK) button.
A - -O T U ' M
LL IN NE YPE SER S
(OK) button.
(OK) button.
(OK) button.
(OK) button.
FC9Y-B1722
ANUAL