iDect FC6A series User Manual page 105

(5) Auto Tuning/auto Reset LEDs [AT0, AT1]
Flashing: When executing auto tuning or auto reset
Off: When auto tuning or auto reset is stopped
(6) Manual Mode LEDs [MT0, MT1]
On: When program control mode is selected
Off: When auto mode is selected
(7) Fixed Value Control Mode/program Control Mode LEDs [F/P0, F/P1]
On: During program control mode
Off: During fixed value control mode
(8) Program Control Execution/hold LEDs [R/H0, R/H1]
On: During program control execution or while control is allowed in fixed value control
Flashing: When there is a power interruption during program control hold or during program control execution
Off: During program control stopped or while control prohibited in fixed value control
(9) External SP Enabled/disabled LEDs [R/L]
On: External SP input is enabled
Off: External SP input is disabled
(10) Terminal Name Label
Indicates terminal numbers.
(11) Cable terminals
These terminals are for connecting cables. Terminal block type (3.81 mm pitch), spring clamp system.
(12) Expansion connector
Connects the expansion modules and the CPU module.
Model List
Module type
Non-contact voltage output
(to drive SSRs)/current
output type
Relay contact output type
Cable Terminal Type I/O Points
Input
Terminal block type
(3.81 mm pitch)
Output
Terminal block type Input
(3.81 mm pitch)
Output
FC6A S M S A
ERIES ICRO MART
Voltage input (0 to 10 V, 0 to 5 V, 1 to 5 V, 0 to 1 V)
Current input (4 to 20 mA, 0 to 20 mA)
2
Thermocouple (K, J, R, S, B, E, T, N, PL-II, C)
Resistance thermometer (Pt100, jPt100)
Voltage output (12V DC digital output)
2
Current output (4 to 20 mA)
Voltage input (0 to 10 V, 0 to 5 V, 1 to 5 V, 0 to 1 V)
Current input (4 to 20 mA, 0 to 20 mA)
2
Thermocouple (K, J, R, S, B, E, T, N, PL-II, C)
Resistance thermometer (Pt100, jPt100)
2 Relay output
- -O T U ' M
LL IN NE YPE SER S ANUAL
2: P S
RODUCT PECIFICATIONS
I/O Signal
FC9Y-B1722
Type No.
FC6A-F2M1
FC6A-F2MR1
2-77