iDect FC6A series User Manual page 136

3: I
NSTALLATION AND
Assembling the CPU Module and a Cartridge
The following procedure describes the assembly of the CPU module (cartridge slot 1) and an analog cartridge.
Insert a flathead screwdriver into each of the screwdriver slots (two locations) on the CPU module (cartridge slot 1) and
1.
remove the dummy cartridge straight off the CPU module by pushing down the dummy cartridge tabs.
Screwdriver Slot
Take care with the vertical orientation of the analog cartridge and firmly push the analog cartridge connector onto cartridge
2.
slot 1 on the CPU module.
Cartridge Slot 1
Do not perform this work when the FC6A Series MicroSmart is powered. Otherwise there is a risk of damage.
•
Caution
Attach and remove the cartridge straight in relation to the CPU module. If you attach or remove the cartridge at an angle,
•
there is a risk of damage or communication failure.
3-6
W
IRING
Analog Cartridge
FC6A S M S
ERIES ICRO MART
Dummy Cartridge
A - -O T U ' M
LL IN NE YPE SER S ANUAL
FC9Y-B1722