iDect FC6A series User Manual page 108

2: P S
RODUCT PECIFICATIONS
Type No.
Input Value per
Step
Data
Data Type in Application Program
Monotonicity
Input Data Out of Range
Maximum Temporary Deviation
during Electrical Noise Tests
Input Filter
Noise Resistance
Recommended Cable for Noise
Immunity
Crosstalk
Between Input and Power Circuit
Isolation Between I/O and Internal Circuit
Between Inputs
Effect of Improper Input Connection
Maximum Permanent Allowed Overload (No Damage)
Selection of Input Type and Input Range
Calibration or Verification to Maintain Rated Accuracy
*1 The arbitrary setting is a function that uses the digital resolution data by scaling it to arbitrary data (that arbitrarily sets the lower limit value and
the upper limit value). The range setting (-32,768 to 32,767) is specified with data registers.
Example: When -5 V is input, 1,024 is displayed as long as the arbitrary setting is not configured, but -500 is displayed when the arbitrary
setting is configured as upper limit value = 1,000 and lower limit value = -1,000, and this makes it easier to intuitively read the input
voltage value.
When the digital resolution data is 12 bits
Lower Limit Value
0
*2 Input data out of range is reflected in the status of the analog module.
Input Internal Circuit
2 MΩ
5 V ≤
mA
+(A)
– (B)
(B)
39 kΩ
2-80
Resistance
Thermometer
Upper Limit Value
4,095
10 Ω
FC6A S M S
ERIES ICRO MART
Type
Pt100
Pt100 (with decimal
point)
JPt100
JPt100 (with decimal
point)
Can be arbitrarily set for each CH in a range between -32,768 to 32,767
Yes
*2
Detectable
±4% or less of full scale
Yes
Current/voltage: Pair shielded cable
Other: Pair cable
None
Transformer isolated
Photocoupler isolated
Photocoupler isolated
No damage
15V DC or lower (0 to 1 V range is 5V DC or lower), 50 mA or lower
Using programming software
Not possible
Switching Signal
Input
A - -O T U ' M
LL IN NE YPE SER S ANUAL
FC6A-F2M1, FC6A-F2MR1
Input Value per Step
1°C (°F)
0.1°C (°F)
1°C (°F)
0.1°C (°F)
FC9Y-B1722
*1