Figure 15-23 Mac Trace Configuration Example; Maintenance Commands - Zte ZXR10 ZSR V2 Configuration Manual (System Management

ZXR10 ZSR V2 Configuration Guide (System Management)

Maintenance Commands

To maintain MAC trace on the ZXR10 ZSR V2, run the following command:
Command
debug macping {all |error | event | info | packet}
ZXR10#
Configuration Example
l Configuration Description
On a VPLS network, the MAC trace network structure is shown in

Figure 15-23 MAC Trace Configuration Example

l Configuration Flow
1. Configure IP addresses. Enable OSPF between PE1 and PE2.
2. Configure LDP between PEs.
3. Configuring L2 VPN VPLS.
4. Configure MAC trace.
l
Configuration Command
Run the following commands on PE1:
PE1(config)#interface loopback1
PE1(config-if-loopback1)#ip address 100.10.10.1 255.255.255.255
PE1(config-if-loopback1)#exit
PE1(config)#interface gei-1/1
PE1(config-if-gei-1/1)#no shutdown
PE1(config-if-gei-1/1)#ip address 17.1.1.1 255.255.255.0
PE1(config-if-gei-1/1)#exit
PE1(config)#router ospf 1
PE1(config-ospf-1)#network 100.10.10.1 0.0.0.0 area 0
PE1(config-ospf-1)#network 17.1.1.1
PE1(config-ospf-1)#exit
PE1(config)#mpls ldp instance 1
PE1(config-ldp-1)#router-id loopback1
PE1(config-ldp-1)#interface gei-1/1
PE1(config-ldp-1-if-gei-1/1)#exit
PE1(config-ldp-1)#exit
SJ-20140504150128-007|2014-05-10 (R1.0)
Function
Displays errors, events, information and
packets or all information when MAC
trace packets are received and sent.
0.0.0.255 area 0
15-36
ZTE Proprietary and Confidential
Figure 15-23.