Dns-Type Sqa Configuration Example; Figure 13-5 Dns-Type Sqa Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

Chapter 13 SQA Configuration
R1#show sqa-result udp
udp test[4] result
SendPackets:1 ResponsePackets:1
Completion:success Destination IP Address: 10.1.0.2
Min/Max/Avg/Sum RTT:61/63/62/622ms
Min/Max/Avg/Sum Positive Jitter:0/0/0/0ms
Min/Max/Avg/Sum Negative Jitter:1/1/1/2ms
Min/Max/Avg/Sum Jitter:1/1/1/2ms
Packet loss rate:0%
Last Probe Time:2012-09-01 23:52:35

13.3.5 DNS-Type SQA Configuration Example

Configuration Description
As shown in Figure 13-5, configure an SQA test instance on ZXR10 ZSR V2, connect the
server to R1, and configure an IP address. Configure a route to the server if necessary so
that DNS packets can be sent to the server.

Figure 13-5 DNS-Type SQA Configuration Example

Configuration Flow
1. Create an SQA test instance.
2. Enter the SQA test instance, configure the domain name to be resolved by the DNS
test and the IP address of the DNS server, and set the number of resolution operations.
3. Set the SQA test start time as right now or at a scheduled time.
4. Check the test result.
Configuration Command
Configuration of R1:
R1(config)#ip domain lookup
R1(config)#ip domain name-server ipv4-address 10.1.0.1
R1(config)#sqa-test 5
R1(config-sqa-5)#type-dns destination-url abc.cn dns-ip 10.1.0.1
R1(config-sqa-5)#sqa-begin now
%Info 757: The sqa test is starting now, wait a moment for test result......
R1(config-sqa-5)#
13-9
SJ-20140504150128-007|2014-05-10 (R1.0) ZTE Proprietary and Confidential