Zte ZXR10 ZSR V2 Configuration Manual (System Management page 124

ZXR10 ZSR V2 Configuration Guide (System Management)
ip flow monitor <monitor-name>: applies a pre-set netflow monitoring policy on the
interface. After the command is run, configurations related to the monitor policy, the
cache size, template in use, and collected fields of the template cannot be modified. To
modify the configurations, the flow monitoring policy must be deleted from the interface
first. Flow active/inactive ageing time and the output policy can be modified.
sampler <sampler-name>: applies a pre-set sampling policy on the interface. The
sampling policy cannot be modified after it is applied on the interface. The modification
takes effect only after it is unbound and then applied on the interface.
unicast | multicast| ipv4–access-list <acl-name>: type of sampled packets. unicast
means sampling unicast packets. multicast means sampling multicast packets. acces
s-list means sampling packets that are filtered with the ACL rules. Up to six different
ACL rules can be used.
In one direction, unicast, multicast, MPLS, and ACL rule packets can be sampled
at the same time. Samples from two directions are not mutually exclusive. If ACL
rule packets are sampled from one direction, however, unicast and multicast packets
cannot be sampled, and vice versa.
6. Verify the configurations.
Command
ZXR10#
ZXR10#
ZXR10#
ZXR10#
netflow-original | ipv4 protocol-port]
ZXR10#
ZXR10#
exclude | include}<line>]
ZXR10#
>[all][|{begin | exclude | include}<line>]
SJ-20140504150128-007|2014-05-10 (R1.0)
show ip flow exporter [<exporter-name>]
show ip flow interface [<interface-name>]
show ip flow monitor [<monitor-name>]
show ip flow record [<record-name>|
show ip flow sampler [<sampler-name>]
show running-config ipflow [all][|{begin |
show running-config-interface <interface-name
Function
Displays a flow exporter policy of the
specified name or all flow exporter
policies.
Displays configurations of the specified
interface or all interfaces.
Displays a flow monitoring policy of the
specified name or all flow monitoring
policies.
Displays a flow record policy of the
specified name, the pre-defined V5
policy (V5 template: netflow-original), or
all flow record policies.
Displays a sampler policy of the
specified name or all sampler policies.
Displays NetFlow configurations, or all
configurations including default values
of un-configured parameters when the
command carries the all parameter.
Displays interface configurations related
to NetFlow.
12-8
ZTE Proprietary and Confidential