Figure 1-2 Run Dialog Box - Zte ZXR10 ZSR V2 Configuration Manual (System Management

Context
Telnet is used for configuring routers remotely. To prevent illegal users from accessing the
router through Telnet, a user name and password have to be set on the router for Telnet
accessing. Only the user who has the preset user name and password can access the
router. For how to configure a user name and password on the ZXR10 ZSR V2 for Telnet
login, refer to
Steps
1. Connect to the ZXR10 ZSR V2 through Telnet.
Assume that the IP address of a remote router is 192.168.3.1 and that the local
terminal (configured with the Windows XP operating system, for example) can access
the remote router network. The operations on the local terminal are as follows:
a. Start the Run program on the local terminal, and enter the telnet 192.168.3.1
command, see

Figure 1-2 Run Dialog Box

b. Click OK.
The following information is displayed:
Login at: 19:46:37 03-24-2014
Username:who
Password:
ZXR10>enable 18
Password:
ZXR10#
c. Enter a user name and a password according to the prompt. Then, you can log in
to the remote router.
2. Configure a Telnet connection.
SJ-20140504150128-007|2014-05-10 (R1.0)
4.2 Configuring User
Figure 1-2.
************************************************************
Welcome to ZXR10 Intelligent Integrated Multi-Service Router
************************************************************
Chapter 1 Device Connection management
Management.
of ZTE Corporation
1-3
ZTE Proprietary and Confidential