Zte ZXR10 ZSR V2 Configuration Manual (System Management page 63

banner
bfd
cfm
check
class-map
clock
--More—
Run the following commands to view ZTE_B's privilege level. The execution result is
displayed as follows:
Username:ZTE_B
Password:
ZXR10#show privilege
Current privilege level is 5
/*Indicates that ZTE_B's privilege level is 5.*/
ZXR10#?
/*Displays the commands that can be used by ZTE_B in privilege configuration mode.*/
Exec commands:
cd
cfm Executing CFM detecting functions
clock
configure
debug
dir
disable
enable
exit
--More—
ZXR10#configure terminal
Enter configuration commands, one per line.
ZXR10(config)#?
/*Displays the commands that can be used by ZTE_B in global configuration mode.*/
Configure commands:
end Exit from configure mode
exit Exit from configure mode
ping
ping6
show Show running system information
trace
trace6
ZXR10(config)#
ZXR10(config)#show ?
clock
SJ-20140504150128-007|2014-05-10 (R1.0)
Change current directory
Manage the system clock
Enter configuration mode
Debugging functions
List files on a filesystem
Turn off privileged commands
Turn on privileged commands
Exit from the EXEC
Send echo messages
Send IPv6 echo messages
Trace route to destination
Trace route to destination using IPv6
Show current system clock
Chapter 5 Command Privilege Level Classification
Terminal line banner
Configure bfd
Enter CFM configuration mode
Configure intervals of check
Configure H-QoS class map
Configure board clock
End with CTRL/Z.
5-5
ZTE Proprietary and Confidential