Lldp Attribute Configuration Example; Figure 14-2 Lldp Neighbor Configuration Example; Figure 14-3 Lldp Attribute Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

ZXR10 ZSR V2 Configuration Guide (System Management)

Figure 14-2 LLDP Neighbor Configuration Example

Configuration Flow
1. Enter LLDP configuration mode.
2. Enter an interface.
3. Enable LLDP.
Configuration Command
Enter an interface in LLDP configuration mode and then configure LLDP, as shown below.
R1(config)#lldp
R1(config-lldp)#interface gei-1/1
R1(config-lldp-if-gei-1/1)#lldp enable
R1(config-lldp-if-gei-1/1)#end
Configuration Verification
Use the show lldp neighbor command to check the configuration result, as shown below.
R1(config)#show lldp neighbor
Capability Codes:
Point,
Local-Port
---------------------------------------------------------------------------
gei-1/1

14.3.2 LLDP Attribute Configuration Example

Configuration Description
As shown in

Figure 14-3 LLDP Attribute Configuration Example

SJ-20140504150128-007|2014-05-10 (R1.0)
N - Other, r - Repeater, B - Bridge, W - WLAN Access
R - Router, T - Telephone, D - DOCSIS Cable Device,
S - Station Only
Chassis-ID Holdtime Capability
0023e4221134 103
Figure 14-3, it is required to configure LLDP attributes on R1.
Platform
B R 6800v1.00.20
14-6
ZTE Proprietary and Confidential
Peer-Port
gei-1/1