Ftp Connection Configuration; Configuring The Zxr10 Zsr V2 As An Ftp Server; Figure 1-6 Ssh Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

ZXR10 ZSR V2 Configuration Guide (System Management)
Example
The following provides an SSH configuration example.
l Configuration Description
It is required to connect a PC to R1 through SSH, see

Figure 1-6 SSH Configuration Example

l
Configuration Flow
1. Connect a PC to R1.
2. Configure SSH on R1.
3. Configure an ACL on R1 to filter connections.
l
Configuration Commands
Run the following commands on R1:
R1(config)#ssh server enable
R1(config)#ssh server access-class ipv4 wd
R1(config)#ipv4-access-list wd
R1(config-ipv4-acl)#rule permit tcp 169.1.108.82 0.0.0.0 any
R1(config-ipv4-acl)#exit
l
Configuration Verification
If no ACL is configured, a PC whose IP address is in any network segment can be
connected to R1.
If an ACL is configured, only PCs whose IP addresses are in the Permit column of
the ACL can be connected to R1.

1.5 FTP Connection Configuration

1.5.1 Configuring the ZXR10 ZSR V2 as an FTP Server

This procedure describes how to configure the ZXR10 ZSR V2 as an FTP server.
Prerequisite
The local terminal can access the remote router network.
Steps
1. Enable the FTP server function.
SJ-20140504150128-007|2014-05-10 (R1.0)
1-10
ZTE Proprietary and Confidential
Figure 1-6.