Netflow V8 Configuration Example; Figure 12-2 Netflow V8 Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

12.3.2 NetFlow V8 Configuration Example

Configuration Description
As shown in
an IP address. Configure a route to the server if necessary so that the NetFlow packets
can be sent to the server.

Figure 12-2 NetFlow V8 Configuration Example

Configuration Flow
1. Enable NetFlow Service.
2. Configure flow exporter output, including the server IP address, port number and
protocol type.
3. Configure sampler, setting sampling rate and sampling mode.
4. Configure the cache size of flow monitor, the active overtime value and the inactive
overtime value. Bind the configured flow exporter to the system v8 module.
5. Bind flow monitor to the interface, and configure the sampling type and direction.
Configuration Command
Configuration on R1:
R1(config)#flow exporter exp
R1(config-flow-exporter)#destination ipv4-address 169.1.109.60
R1(config-flow-exporter)#transport udp 2055
R1(config-flow-exporter)#export-protocol netflow-v8
R1(config-flow-exporter)#exit
R1(config)#sampler sam
R1(config-sampler)#mode deterministic 1-out-of 1024
R1(config-sampler)#exit
R1(config)#flow monitor mo
R1(config-flow-monitor)#cache entries 4096
R1(config-flow-monitor)#exporter exp
R1(config-flow-monitor)#record netflow ipv4 protocol-port
R1(config-flow-monitor)#cache timeout inactive 60
R1(config-flow-monitor)#cache timeout active 10
R1(config-flow-monitor)#exit
SJ-20140504150128-007|2014-05-10 (R1.0)
Figure 12-2, configure NetFlow on R1, connect the server to R1, and configure
Chapter 12 NetFlow Configuration
12-11
ZTE Proprietary and Confidential