Figure 15-12 Pwe3 Lsp Ping Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

ZXR10 ZSR V2 Configuration Guide (System Management)
Codes: '!' - success,
ut,
ismatch,
label,
wn return code, 'x' - return code 0
QQQQQ
Success rate is 0 percent(0/5).
PWE3 LSP Ping Configuration Example
l
Configuration Description
As shown in
configure LSP ping on R1 to check connectivity.

Figure 15-12 PWE3 LSP Ping Configuration Example

l
Configuration Flow
1. Build an L2 VPN network.
2. Perform PWE3 LSP ping on R1.
l
Configuration Commands
Basic LDP configuration is omitted here.
l
Configuration Verification
Run the following command to check configurations on R1. The execution result is
displayed as follows:
R1#show l2vpn forwardinfo vpnname zte
Hearders: PWType - Pseudowire type and Pseudowire connection mode
Codes:
PWName
pw1
SJ-20140504150128-007|2014-05-10 (R1.0)
'L' - labeled output interface, 'B' - unlabeled output interface,
'D' - DS Map mismatch,
'M' - malformed request,
'P' - no rx intf label prot,
'R' - transit router,
'd' - DDMAP
Figure 15-12, R1, R2 and R3 form an L2 VPN network. It is required to
Llabel - Local label, Rlabel - Remote label
VPNowner - owner type and instance name
H - HUB mode, S - SPOKE mode, L - VPLS, W - VPWS, M – MSPW, MO - MONITOR
$pw - auto_
PeerIP FEC PWType
10.28.0.4 128 Ethernet
'Q' - request not sent,
'F' - no FEC mapping,
'm' - unsupported tlvs,
'p' - premature termination of LSP,
'I' - unknown upstream index, 'X' - unkno
State Llabel
H UP 81938
15-20
ZTE Proprietary and Confidential
'.' - timeo
'f' - FEC m
'N' - no rx
Rlabel VPNowner
82241 L:zte