Configuring Mac Trace - Zte ZXR10 ZSR V2 Configuration Manual (System Management

ZXR10 ZSR V2 Configuration Guide (System Management)
Run the following commands on PE1:
PE1(config)#interface loopback1
PE1(config-if-loopback1)#ip address 100.10.10.1 255.255.255.255
PE1(config-if-loopback1)#exit
PE1(config)#interface gei-1/1
PE1(config-if-gei-1/1)#no shutdown
PE1(config-if-gei-1/1)#ip address 10.1.1.1 255.255.255.0
PE1(config-if-gei-1/1)#exit
PE1(config)#router ospf 1
PE1(config-ospf-1)#network 100.10.10.1 0.0.0.0 area 0
PE1(config-ospf-1)#network 10.1.1.1 0.0.0.255 area 0
PE1(config-ospf-1)#exit
PE1(config)#mpls ldp instance 1
PE1(config-ldp-1)#router-id loopback1
PE1(config-ldp-1)#interface gei-1/1
PE1(config-ldp-1-if-gei-1/1)#exit
PE1(config-ldp-1)#exit
PE1(config)#mpls l2vpn enable
PE1(config)#pw pw1
PE1(config)#vpls zte1
PE1(config-vpls-zte1)#pseudo-wire pw1
PE1(config-vpls-zte1–pw-pw1)#neighbour 100.10.10.2 vcid 10
PE1(config-vpls-zte1–pw-pw1–neighbour-100.10.10.2)#end
PE1(config)#zmac-oam enable /*Enable mac-ping(trace) globally.*/
Configurations on PE2 are similar to those on PE1.
l Configuration Verification
Run the mac-ping command on PE1. The execution result is displayed as follows:
PE1#mac-ping 00d0.d000.0500 vpls zte1 peer 100.10.10.2 summary
sending 5,92-byte EOAM echo(es) to 00d0.d000.0500,timeout is 2 seconds.
!!!!!
Success rate is 100 percent(5/5),round-trip min/avg/max= 1/1/2 ms.

15.12 Configuring MAC Trace

Overview
MAC trace provides a method of monitoring performance and detecting errors at the MAC
layer. It determines whether the nodes at the link layer are operating properly by sending
and receiving EOAM MAC trace packets.
SJ-20140504150128-007|2014-05-10 (R1.0)
15-34
ZTE Proprietary and Confidential