Figure 15-9 Ip Trace Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

ZXR10 ZSR V2 Configuration Guide (System Management)
Maintenance Commands
The following example shows the output of the trace command used in privileged mode.
The trace command traces the path to 168.1.10.100.
ZXR10#trace 168.1.10.100
tracing the route to 168.1.10.100
1 168.1.10.100
[finished]
Descriptions of the command output:
Command Output
1
168.1.10.100
2 ms 3 ms 5 ms
Configuration Example
l
Configuration Description
As shown in

Figure 15-9 IP Trace Configuration Example

l Configuration Flow
1. Configure interface addresses and routes.
2. Run the trace command in privileged mode.
l
Configuration Commands
Run the following commands on R1:
R1(config)#interface gei-1/1
R1(config-if-gei-1/1)#no shutdown
R1(config-if-gei-1/1)#ip address 100.0.0.15 255.255.255.0
R1(config-if-gei-1/1)#exit
R1(config)#router ospf 1
R1(config-ospf-1)#network 100.0.0.0 0.0.0.255 area 0
R1(config-ospf-1)#end
l
Configuration Verification
The execution result of the trace command on R1 is displayed as follows:
R1#trace 175.103.59.110
tracing the route to 175.103.59.110
SJ-20140504150128-007|2014-05-10 (R1.0)
2 ms 3 ms 5 ms
Description
The sequence number of a router along the route to the
destination.
The IP address of a router along the route. The last IP
address is the destination.
The time of three each round trip for detection.
Figure 15-9, the trace command is run on R1 to detect the route to R2.
15-14
over a maximum of 30 hops:
ZTE Proprietary and Confidential