Configuring The Alarm Function - Zte ZXR10 ZSR V2 Configuration Manual (System Management

ZXR10 ZSR V2 Configuration Guide (System Management)
different. The device compares the temperature information obtained at specified
time with the corresponding alarm threshold.
threshold, the alarm is reported. If the temperature is lower than the threshold, the
alarm at the corresponding level is cleared.
l
Power Voltage Alarm
If the voltage range not in the normal working voltage range, the power voltage alarm
is reported.

7.2 Configuring the Alarm Function

This procedure describes how to configure the alarm function.
Steps
1. Configure the basic alarm function.
Step
1
2
3
4
5
6
SJ-20140504150128-007|2014-05-10 (R1.0)
Command
logging on
ZXR10(config)#
logging buffer < buffer-size>
ZXR10(config)#
logging timestamps [datetime
ZXR10(config)#
localtime | precisetime | uptime]
logging level <level>
ZXR10(config)#
logging console <level>
ZXR10(config)#
logging Trap-enable <level>
ZXR10(config)#
If the temperature exceeds the
Function
Enables the alarm recording function,
so that alarms can be reported to log,
control terminal, SNMP, and SYSLOG.
Sets the size of the alarm log buffer.
Unit: KB, range: 100–1000, default:
200.
Sets the display mode of alarm time.
Default: datetime localtime.
Configures the level to save alarms
into logs. Alarms whose levels are
higher than this level are recorded in
logs.
Default: INFORMATIONAL (level 7).
Configures the level to display alarms
on a console or Telnet terminal.
Alarms whose levels are higher than
this level are displayed on a console
or Telnet terminal.
Default: NOTIFICATIONS (level 6).
Configures the level to report alarms
to SNMP in Trap mode. Alarms whose
levels are higher than this level are
reported to SNMP in Trap mode. By
default, alarms are not reported.
7-2
ZTE Proprietary and Confidential