Figure 8-1 Syslog Configuration Example Topology - Zte ZXR10 ZSR V2 Configuration Manual (System Management

Figure 8-1 Syslog Configuration Example Topology

Configuration Flow
1. Connect the Syslog server to the ZXR10 ZSR V2.
2. Configure the interface on the Syslog server and the interface on the ZXR10 ZSR V2,
which are directly connected in the same network segment.
3. Configure the Syslog server alarm level.
4. Configure the Syslog type.
5. Specify the address of the Syslog server.
Configuration Command
Run the following commands on the ZXR10 ZSR V2:
R1(config)#interface gei-2/1
R1(config-if-gei-2/1)#no shutdown
R1(config-if-gei-2/1)#ip address 1.1.1.2 255.255.255.0
R1(config-if-gei-2/1)#exit
R1(config)#syslog level warnings
/*Configures the alarm level of Syslog as WARNINGS*/
R1(config)#syslog-server facility syslog
/*Configures the type of Syslog as syslog*/
R1(config)#syslog-server host 1.1.1.1
/*Configure an IP address of the Syslog server*/
Configuration Verification
Run the show command to check the configurations. The execution result is displayed as
follows:
R1(config)#show running-config alarm
!<ALARM>
syslog level warnings
syslog-server facility syslog
syslog-server host 1.1.1.1 alarmlog cmdlog debugmsg servicelog
braslog natlog
!</ALARM>
SJ-20140504150128-007|2014-05-10 (R1.0)
Chapter 8 SYSLOG Configuration
8-3
ZTE Proprietary and Confidential