Chapter 5
Command Privilege Level
Classification
Table of Contents
Command Privilege Level Overview ...........................................................................5-1
Configuring Command Privilege ................................................................................5-1
Command Privilege Level Configuration Example ......................................................5-2
5.1 Command Privilege Level Overview
The ZXR10 ZSR V2 supports the command privilege level function. Command privilege
level management is used to configure command privileges. Users can run the privilege
command to configure the privilege of a command.
Command privilege levels range from level 1 to level 15. Different commands can be
configured with different privilege levels. After a user logs in, a command view is displayed
according to the user's privilege level. Therefore, the user cannot run commands whose
privilege levels are higher than the user's level. Users with the highest level (that is,
administrators with level 15) can set privilege levels for commands.
5.2 Configuring Command Privilege
This procedure describes how to configure command privileges.
Steps
1. Configure command privileges.
Command
ZXR10(config)#
default}<command-keywords>
ZXR10(config)#
<command-keywords>
[all]: all commands beginning with this keyword.
level <level>: privilege level, range: 1–15
default: default command privilege level.
<command-keywords>: command keywords, range: 1–200 characters.
SJ-20140504150128-007|2014-05-10 (R1.0)
privilege <logic-mode>[all] level {<level>|
no privilege <logic-mode>[all] node
5-1
Function
Configures a command privilege
level.
Restores the default command
privilege level.
ZTE Proprietary and Confidential