Zte ZXR10 ZSR V2 Configuration Manual (System Management page 177

Chapter 15 Network Layer Detection
R1(config-if-gei-1/9)#ip address 12.131.1.1 255.255.255.0
R1(config-if-gei-1/9)#exit
R1(config)#interface gei-1/8
R1(config-if-gei-1/8)#no shutdown
R1(config-if-gei-1/8)#ip address 17.1.1.2 255.255.255.0
R1(config-if-gei-1/8)#exit
R1(config)#interface loopback1
R1(config-if-loopback1)#ip address 3.3.3.3 255.255.255.0
R1(config-if-loopback1)#exit
/*Configure a multicast protocol*/
R1(config)#ip multicast-routing
R1(config-mcast)#router pim
R1(config-mcast-pim)#rp-candidate loopback1
R1(config-mcast-pim)#bsr-candidate loopback1
R1(config-mcast-pim)#interface gei-1/9
R1(config-mcast-pim-if-gei-1/9)#pimsm
R1(config-mcast-pim-if-gei-1/9)#exit
R1(config-mcast-pim)#interface gei-1/8
R1(config-mcast-pim-if-gei-1/8)#pimsm
R1(config-mcast-pim-if-gei-1/8)#end
Configurations on R2 are similar to those on R1. Configure an IP address and enable
a multicast protocol on R2.
Run the following command on R2 to add a static route to the RP:
R2(config)#ip route 3.3.3.3 255.255.255.255 17.1.1.2
l Configuration Verification
Run the ping command on R1 to check whether the receiving group has joined the
225.0.0.1 multicast group. The execution result is displayed as follows:
R1#ping 225.0.0.1
sending 5,100-byte ICMP echoes to 225.0.0.1,timeout is 2 seconds.
Reply to request 1 received from 17.1.1.1, 2 ms
Reply to request 2 received from 17.1.1.1, 2 ms
Reply to request 3 received from 17.1.1.1, 2 ms
Reply to request 4 received from 17.1.1.1, 2 ms
Reply to request 5 received from 17.1.1.1, 2 ms
Success rate is 100 percent(5/5),round-trip min/avg/max= 2/2/2 ms.
15-29
SJ-20140504150128-007|2014-05-10 (R1.0) ZTE Proprietary and Confidential