Figure 15-11 Rsvp Lsp Ping Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

Figure 15-11 RSVP LSP Ping Configuration Example

l
Configuration Flow
1. Build an OSPF-TE network.
2. Perform RSVP LSP ping on R1.
l
Configuration Command
For RSVP configuration, refer to the OSPF-TE configuration example.
l
Configuration Verification
Run the following command to check configurations on R1. The execution result is
displayed as follows:
R1#show mpls traffic-eng tunnels brief
Signalling Summary:
LSP Tunnels Process:
RSVP Process:
Forwarding:
TUNNEL NAME
tunnel_4000
tunnel_1
Test connectivity of the tunnel on R1. The execution result is displayed as follows:
R1#ping mpls traffic-eng te_tunnel1 /*TE tunnel of LSP Ping UP on R1*/
sending 5,120-byte MPLS echo(es) to te_tunnel1,timeout is 2 second(s).
Codes: '!' - success,
ut,
ismatch,
label,
wn return code, 'x' - return code 0
!!!!!
Success rate is 100 percent(5/5),round-trip min/avg/max= 2/3/6 ms.
R1#ping mpls traffic-eng te_tunnel4000 /*TE tunnel of LSP Ping DOWN on R1*/
sending 5,120-byte MPLS echos to te_tunnel4000,timeout is 2 seconds.
SJ-20140504150128-007|2014-05-10 (R1.0)
DESTINATION
10.28.0.5
10.28.0.4
'L' - labeled output interface, 'B' - unlabeled output interface,
'D' - DS Map mismatch,
'M' - malformed request,
'P' - no rx intf label prot,
'R' - transit router,
'd' - DDMAP
Chapter 15 Network Layer Detection
running
running
enabled
UP IF DOWN IF
- unknown
- gei-1/2
'Q' - request not sent,
'F' - no FEC mapping,
'm' - unsupported tlvs,
'p' - premature termination of LSP,
'I' - unknown upstream index, 'X' - unkno
15-19
ZTE Proprietary and Confidential
STATE/PROT
up/down
up/up
'.' - timeo
'f' - FEC m
'N' - no rx