Udp-Type Sqa Configuration Example; Figure 13-4 Udp-Type Sqa Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

ZXR10 ZSR V2 Configuration Guide (System Management)

13.3.4 UDP-Type SQA Configuration Example

Configuration Description
As shown in
can be forwarded properly. Enable a monitoring port of SQA-UDP-server on R3.

Figure 13-4 UDP-Type SQA Configuration Example

Configuration Flow
1. Create an SQA test instance.
2. Enter the SQA test instance, and configure the UDP test attribute for the instance,
such as the UDP test destination address and port number.
3. Set the SQA test start time as now or at a scheduled time.
4. Check the test result.
Configuration Command
The configuration of R3:
R3(config)#sqa-udp-server 10.1.0.2 10000
The configuration of R1:
R1(config)#sqa-test 4
R1(config-sqa-4)#type-udp 10.1.0.2 10000
R1(config-sqa-4)#sqa-begin now
%Info 757: The sqa test is starting now, wait a moment for test result......
R1(config-sqa-4)#
Configuration Verification
The configuration and test result are shown below.
R1#show sqa-test 4
test number:1
test type: UDP
destination IP:10.1.0.2
desitnation port:10000
size: 50
interval time:100
repeat:1
send trap:disable
SJ-20140504150128-007|2014-05-10 (R1.0)
Figure 13-4, there is a link between R1 and R3. Packets between R1 and R3
13-8
ZTE Proprietary and Confidential