Figure 13-3 Tcp-Type Sqa Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

Chapter 13 SQA Configuration

Figure 13-3 TCP-Type SQA Configuration Example

Configuration Flow
1. Create an SQA test instance.
2. Enter the SQA test instance, and configure the TCP test attribute for the test instance,
such as the TCP test destination address and port number.
3. Set the SQA test start time as now or at a scheduled time.
4. Check the test result.
Configuration Command
The configuration of R3:
R3(config)#sqa-tcp-server 10.1.0.2 10000
The configuration of R1:
R1(config)#sqa-test 3
R1(config-sqa-3)#type-tcp 10.1.0.2 10000
R1(config-sqa-3)#sqa-begin now
%Info 757: The sqa test is starting now, wait a moment for test result......
R1(config-sqa-3)#
Configuration Verification
The configuration and test result are shown below.
R1#show sqa-test 3
test number:1
test type: TCP
destination IP:10.1.0.2
desitnation port:10000
interval time:1000
repeat:1
send trap:disable
R1#show sqa-result tcp
tcp test[3] result
SendPackets:1 ResponsePackets:1
Completion:success Destination Ip Address:10.1.0.2
Min/Max/Avg/Sum RTT:5/5/5/5ms
Last Probe Time:2012-07-29 09:45:49
13-7
SJ-20140504150128-007|2014-05-10 (R1.0) ZTE Proprietary and Confidential