ZXR10 ZSR V2 Configuration Guide (System Management)
R1(config)#interface gei-6/6
R1(config-if-gei-6/6)#no shutdown
R1(config-if-gei-6/6)#ip flow monitor mo sampler sam unicast input
R1(config-if-gei-6/6)#exit
Configuration Verification
Verify the configuration on R1 as shown below.
R1#show running-config ipflow
! < ipflow >
sampler sam
mode deterministic 1-out-of 1024
$
flow exporter exp
destination ipv4-address 169.1.109.60
export-protocol netflow-v8
$
flow monitor mo
cache timeout active 10
cache timeout inactive 60
record netflow ipv4 protocol-port
exporter exp
$
interface gei-6/6
ip flow monitor mo sampler sam unicast input
$
! </ ipflow >
12.3.3 NetFlow V9 Configuration Example
Configuration Description
As shown in
an IP address. Configure a route to the server if necessary so that the NetFlow packets
can be sent to the server.
Figure 12-3 NetFlow V9 Configuration Example
SJ-20140504150128-007|2014-05-10 (R1.0)
Figure
12-3, configure NetFlow on R1, connect the server to R1, and configure
12-12
ZTE Proprietary and Confidential