Figure 15-21 Mac Ping Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

packet, PE2 sends a reply packet. If PE1 receives the reply packet within a specified
period, the link layer is operating properly.
Configuration Commands
To configure MAC ping on the ZXR10 ZSR V2, run the following command:
Command
mac-ping <destination-mac>{interface <out-port>| vpls
ZXR10#
<vpls-name> peer <peer-address>|vpws<vpws-name> peer
<peer-address>}{summary | detail}{[external-vlan <external-vlan>
internal-vlan <internal-vlan>]|[vlan <vlan-id>]}[repeat
<repeat-count>][timeout <timeout>]
<out-port>: egress interface of a request packet on a CE.
summary : briefly displays MAC ping results.
detail: displays MAC ping results in detail.
<repeat-count>: repeat count, range: 1–65536, default: 1.
<peer-address>: remote router ID to be detected on a PE.
Maintenance Commands
To maintain MAC ping on the ZXR10 ZSR V2, run the following command:
Command
debug macping {all |error | event | info | packet}
ZXR10#
Configuration Example
l
Configuration Description
For the MAC ping network structure on a VPLS network, see

Figure 15-21 MAC Ping Configuration Example

l
Configuration Flow
1. Configure IP addresses. Enable OSPF between PE1 and PE2.
2. Configure LDP between PEs.
3. Configuring L2 VPN VPLS.
4. Configure MAC ping.
l
Configuration Commands
SJ-20140504150128-007|2014-05-10 (R1.0)
Chapter 15 Network Layer Detection
Function
Displays errors, events, information,
packets or all information when MAC ping
packets are received and sent.
15-33
ZTE Proprietary and Confidential
Function
Checks the connectivity of the
destination MAC address.
Figure 15-21.