Zte ZXR10 ZSR V2 Configuration Manual (System Management page 58

ZXR10 ZSR V2 Configuration Guide (System Management)
There are two methods for configuring an "enable" password to raise user's privilege level
to the highest level:
l
In global configuration mode, run the enable secret level command. For details, refer
to "Chapter 5 Command Privilege Level Classification".
l
In global configuration mode, run the nvram enable-password command. For details,
refer to the Setting Configurations Kept in NVRAM section the ZXR10 ZSR V2 Initial
Configuration Guide.
You can configure the recovery function for a password configured in the NVRAM.
R1(config)#enable secret recover-remind
password:*****
question:zte
answer:zte
/*If you forget the local enable password, you can run the recover-enable command
under privilege level 1 to restore the default password.*/
R1>recover-enable
question:zte
answer:***
%Info 40449: Recover-enable ok! New enable password is: zxr10.
Configuration Verification
Configure a corresponding enable password on the AAA server. After the user logs in
normally and passes authentication, the user privilege level is raised.
SJ-20140504150128-007|2014-05-10 (R1.0)
4-20
ZTE Proprietary and Confidential