Chapter 12 Netflow Configuration; Configuring Netflow - Zte ZXR10 ZSR V2 Configuration Manual (System Management

12.2 Configuring NetFlow

This procedure describes how to configure the NetFlow function.
Steps
1. Configure NetFlow exporter policies.
Step
1
2
3
4
5
6
7
refresh <packets>: the number of output netflow packets, according to which the
module is resent, range: 1–600, default: 20.
timeout <seconds>: time, according to which the module is resent, range: 1–86400,
default: 600 seconds.
SJ-20140504150128-007|2014-05-10 (R1.0)
Command
flow exporter <exporter-name>
ZXR10(config)#
ZXR10(config-flow-exporter)#
{ipv4-address <ip-address>|[vrf <name>]}
ZXR10(config-flow-exporter)#
{netflow-v5 | netflow-v8 | netflow-v9 | ipfix }
ZXR10(config-flow-exporter)#
{refresh <packets>| timeout <seconds>}
ZXR10(config-flow-exporter)#
<port>
ZXR10(config-flow-exporter)#
{ipv4-address <ip-address>}
ZXR10(config-flow-exporter)#

Chapter 12 NetFlow Configuration

destination
export-protocol
template data
transport udp
source
dscp <value>
12-3
ZTE Proprietary and Confidential
Function
Creates a flow exporter policy,
and names the policy. You can
configure up to 200 different flow
exporter policies.
Range of the policy name: 1–32
characters.
Configures the IPv4 address of
the NetFlow server.
Sets the format of NetFlow output
packets.
The output packet format can
be NetFlow v5, v8, v9, or ipfix,
default: netflow-v9 .
When the format is set to
v5, the template must be
netflow-original.
When the format is v8, the
template must be netflow ipv4
protocol-port.
Resends module according to the
number of packets or time.
Sets the NetFlow output protocol
to UDP and sets the port number.
Range: 1–65535, default: 2055.
Configures the source IPv4
address of NetFlow packets sent.
Sets the TOS field in the IP
header when a Netflow packet is
sent. Range: 0–63, default: 0.