Zte ZXR10 ZSR V2 Configuration Manual (System Management page 129

Configuration Flow
1. Enable NetFlow Service.
2. Configure flow exporter output, including server IP address, port number and protocol
type, module refresh time and refresh rate.
3. Configure match and collect of flow record policy.
4. Configure the size of flow monitor cache, active overtime value and inactive overtime
value, bind the configured flow exporter policy and flow record policy.
5. Configure sampler sampling rate and sampling mode.
6. Bind flow monitor policy to interface, configure sampling type and direction.
Configuration Command
Configuration on R1:
ZXR10(config)#flow exporter exp
R1(config-flow-exporter)#destination ipv4-address 169.1.109.60
R1(config-flow-exporter)#transport udp 2055
R1(config-flow-exporter)#export-protocol netflow-v9
R1(config-flow-exporter)#template data refresh 20
R1(config-flow-exporter)#template data timeout 60
R1(config-flow-exporter)#exit
R1(config)#sampler sam
R1(config-sampler)#mode deterministic 1-out-of 1024
R1(config-sampler)#exit
R1(config)#flow record rec
R1(config-flow-record)#match ipv4 source address
R1(config-flow-record)#match ipv4 destination address
R1(config-flow-record)#match transport source-port
R1(config-flow-record)#match transport destination-port
R1(config-flow-record)#collect counter bytes
R1(config-flow-record)#collect counter packets
R1(config-flow-record)#exit
R1(config)#flow monitor mo
R1(config-flow-monitor)#cache entries 4096
R1(config-flow-monitor)#cache timeout active 60
R1(config-flow-monitor)#cache timeout inactive 10
R1(config-flow-monitor)#exporter exp
R1(config-flow-monitor)#record rec
R1(config-flow-monitor)#exit
R1(config)#interface gei-6/6
R1(config-if-gei-6/6)#no shutdown
R1(config-if-gei-6/6)#ip flow monitor mo sampler sam unicast input
SJ-20140504150128-007|2014-05-10 (R1.0)
Chapter 12 NetFlow Configuration
12-13
ZTE Proprietary and Confidential