Zte ZXR10 ZSR V2 Configuration Manual (System Management page 121

Step
4
SJ-20140504150128-007|2014-05-10 (R1.0)
Command
ZXR10(config-flow-record)#
[long]| packets [long]}
ZXR10(config-flow-record)#
{destination-address | source-address}
ZXR10(config-flow-record)#
{direction|sample-rate}
ZXR10(config-flow-record)#
{input | output}
ZXR10(config-flow-record)#
{[destination address | address-prefix
minimum-mask <len>]|[source address |
address-prefix minimum-mask <len>]}
ZXR10(config-flow-record)#
–
stack section <1
5>
ZXR10(config-flow-record)#
as-number {destination | source | next-adjacent |
prev-adjacent}| next-hop-address {ipv4 | ipv6}}
ZXR10(config-flow-record)#
{sys-uptime {first | last}| absolute {first-millisec |
last-millisec}}
Chapter 12 NetFlow Configuration
collect counter {bytes
collect datalink mac
collect flow
collect interface
collect ipv4
collect mpls label
collect routing {bgp
collect timestamp
12-5
ZTE Proprietary and Confidential
Function
Sets the number and byte number
of flow packets as a non-key
fields.
bytes: This field has 4 bytes.
bytes long: This field has 8 bytes.
packets : This field has 4 bytes.
packets long: This field has 8
bytes.
Sets the source MAC address or
destination MAC address as a
non-key field.
Sets the flow direction or
sampling rate as a non-key field.
Sets the input interface index
or output interface index as a
non-key field.
Sets IPv4 information as a
non-key field.
Sets MPLS information as a
non-key field.
Sets the route next hop
information as a non-key field.
Sets the time or absolute time
when a flow is switched for the
first or last time as non-key field.
sys-uptime first: sets the system
power-up time when the flow
arrives at the cache for the first
time as a collected non-key field.
Unit: ms.
sys-uptime last: sets the system
power-up time when the flow is
updated in the cache for the last
time as the collected non-key
field. Unit: ms.