Netflow Configuration Examples; Netflow V5 Configuration Example; Figure 12-1 Netflow V5 Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

Command
ZXR10#
– End of Steps –

12.3 NetFlow Configuration Examples

12.3.1 NetFlow V5 Configuration Example

Configuration Description
As shown in
an IP address. Configure a route to the server if necessary so that the NetFlow packets
can be sent to the server.

Figure 12-1 NetFlow V5 Configuration Example

Configuration Flow
1. Enable NetFlow Service.
2. Configure flow exporter output, including server IP address, port number and protocol
type.
3. Configure sampler sampling rate and sampling mode.
4. Configure the size of flow monitor cache, active overtime value and inactive overtime
value, bind the configured flow exporter to system v5 module.
5. Bind flow monitor policy to interface, configure sampling type and direction.
Configuration Command
Configuration on R1:
R1#configure terminal
R1(config)#flow exporter exp
R1(config-flow-exporter)#destination ipv4-address 169.1.109.60
R1(config-flow-exporter)#transport udp 2055
R1(config-flow-exporter)#export-protocol netflow-v5
R1(config-flow-exporter)#exit
SJ-20140504150128-007|2014-05-10 (R1.0)
show ip flow service-cpu
Figure 12-1, configure NetFlow on R1, connect the server to R1, and configure
Chapter 12 NetFlow Configuration
Function
Displays information on the service CPU
when the NetFlow function is enabled.
12-9
ZTE Proprietary and Confidential