Juniper QFX5100 Hardware Manual page 216

QFX5100 Switch Hardware Guide
Related
Documentation
196
Ensure that the rack is stable and secured to the building.
Ensure that there is enough space to place the removed QFX5100 device in its new
location and along the path to the new location.
Read "General Safety Guidelines and Warnings" on page
Use the appropriate power off sequence for your configuration to safely powered off
the device.
If the QFX5100 device is being used as a standalone switch, a member in a QFX
Virtual Chassis, or either a spine device or a leaf device in a Virtual Chassis Fabric
(VCF), see "Powering Off a QFX5100 Device" on page
If the QFX5100 device is configured as either a Node device or as a Interconnect
device in a QFabric system, see Adding or Replacing a Node Device in a QFabric Node
Group .
Disconnect the power cords.
Ensure that you have disconnected any cables or wires attached to the QFX5100 switch
ports.
Ensure that you have the following parts and tools available:
A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack
mounting screws, for mounting the QFX5100 device on the rack.
To remove a QFX5100 device from a rack or cabinet:
Have one person support the weight of the switch while another person uses the
1.
screwdriver to remove the front mounting screws that attach the chassis mounting
brackets to the rack or cabinet.
Remove the QFX5100 device from the rack or cabinet.
2.
Use the screwdriver to remove the mounting screws that attach the mounting blades
3.
attached to the rear of the rack or cabinet.
Place the removed screws and mounting blades in a labeled bag. You will need them
4.
when you reinstall the chassis.
Transport the QFX5100 device to your desired new location.
5.
Mounting a QFX5100 Device in a Rack or Cabinet on page 160
239.
193.
Copyright © 2016, Juniper Networks, Inc.