Juniper QFX5100 Hardware Manual page 144

QFX5100 Switch Hardware Guide
Table 39: Interface Support for 40-Gigabit Ethernet QSFP+ Transceivers for the QFX
Series (continued)
Standards
Specifications
Compliance
Juniper Networks Product SKU Number
proprietary 4x10G-IR
PSM
Supported models
Signaling rate
Connector type
Fiber pairs
Transmitter center
wavelength ranges
RMS spectral width
(maximum)
Average transmit launch
power, each lane (minimum)
Average transmit launch
power, each lane (maximum)
Receiver center wavelength
range
Average receive power, each
lane (minimum)
Average receive power, each
lane (maximum)
Receiver sensitivity (OMA),
each lane (maximum)
DOM
Fiber type
124
JNP-QSFP-4x10GE-IR
QFX5100-24Q
QFX5100-48S
QFX5100-48T
QFX5100-96S
10.3125 GBd +/- 100 ppm
12-ribbon single-mode fiber cable with female, MPO/APC connector.
To channelize a 40-Gigabit port to four 10-Gigabit ports, use a 12-fiber
parallel to 2-fiber duplex breakout cable.
NOTE: See "Cable Specifications for QSFP+ and QSFP28 Transceivers"
on page 147 for more information.
4
1290.5 nm through 1355 nm
2.4 nm
-10.4 dBm
1.5 dBm
1260 nm through 1355 nm
-13 dBm
1.5 dBm
-12.6 dBm
Available
SMF
Parallel single
mode
Copyright © 2016, Juniper Networks, Inc.