Interface Specifications For Qsfp+ Dac Breakout Cables For The Qfx Series; Table 45: Qsfp+ To Sfp+ Active Optical Breakout Cables - Juniper QFX5100 Hardware Manual

Table 45: QSFP+ to SFP+ Active Optical Breakout Cables

Characteristic
Standards compliance
Product SKU number
Signaling rate, each lane (range)
Operating range
Diagnostic support
Minimum Junos OS release
Related
Documentation

Interface Specifications for QSFP+ DAC Breakout Cables for the QFX Series

Copyright © 2016, Juniper Networks, Inc.
Value
SFF-8431
SFF-8432
SFF-8436
SFF-8472
JNP-QSFP-AOCBO-xx
10.3125 GBd +/-100 ppm
JNP-QSFP-AOCBO-1M
JNP-QSFP-AOCBO-3M
JNP-QSFP-AOCBO-5M
JNP-QSFP-AOCBO-7M
JNP-QSFP-AOCBO-10M
SFP+ end module: Supported
QSFP+ end module: Only case temperature and power supply voltage supported
14.1X53-D40
Interface Support for the QFX5100 Device on page 86
Quad small form-factor pluggable plus (QSFP+) transceiver to four SFP+ direct-attach
copper (DAC) breakout cables are suitable for in-rack connections between servers and
the QFX Series.
Table 46 on page 136 describes the Junos OS software releases that support third-party
DAC breakout cables. Earlier releases do not support third-party breakout cables.
You can use breakout cables purchased from a third party. These cables should meet
the specifications described in
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
Chapter 8: Port and Interface Specifications
1 m (3.3 ft.)
3 m (9.8 ft.)
5 m (16.4 ft.)
7 m (22.9 ft.)
10 m (32.8 ft.)
Table 47 on page 137.
135