Copyright © 2016, Juniper Networks, Inc.
Using both hands, place the expansion module in the empty slot and slide it in gently
5.
until it is fully seated.
NOTE:
After you have removed an expansion module, wait for at least 5
seconds before you install an expansion module. If you do not wait for at
least 5 seconds, the interfaces on the expansion module might not come
up.
Raise the handle and tighten the captive screws by using your fingers or the screwdriver.
6.
For the QFX5100-24Q-AA, retract the ejector handles and tighten the captive screws
by using your fingers or the screwdriver (see
turns green, the expansion module is ready for use.
Figure 81 on page 209
shows how to install a QSFP+ expansion module on the port panel
of a QFX5100-24Q device.
Figure 81: Installing a QFX-EM-4Q Expansion Module in a QFX5100-24Q
Device
Figure 82 on page 209
shows how to install a QFX-PFA-4Q on the port panel of a
QFX5100-24Q-AA switch.
Figure 82: Installing a QFX-PFA-4Q Expansion Module in a
QFX5100-24Q-AA Device
Chapter 18: Replacing Expansion Module
Figure 82 on page
209). When the
ST
LED
209