Juniper QFX5100 Hardware Manual page 187

Related
Documentation
Copyright © 2016, Juniper Networks, Inc.
Configure into mixed mode if there are QFX3600, QFX3500, or EX4300 switches
4.
operating as leaf devices in the VCF.
Configure each device for one of the provisioning modes: autoprovision, preprovision,
5.
or nonprovision. See:
Autoprovisioning a Virtual Chassis Fabric
Preprovisioning a Virtual Chassis Fabric
Configuring a Nonprovisioned Virtual Chassis Fabric
Connect and configure one of the management ports (C0) or (C1) to a management
6.
switch as the Virtual Management Ethernet interface. Using this interface, you can
configure and manage the devices in the VCF. See
a Network for Out-of-Band Management" on page
Commit your changes.
7.
Cable the QSFP+ or SFP+ ports. For cabling examples, see
8.
Device in a Virtual Chassis Fabric" on page
Switch in a Virtual Chassis Fabric, and Connecting EX Series Switches in a Virtual Chassis
Fabric.
If you configured your devices as either autoprovisioned or preprovisioned, the Virtual
Chassis ports (VCP) are automatically configured. If you configure the devices as
nonprovisioned, you must manually configure the VCPs.
Understanding Virtual Chassis Fabric Configuration
Planning a Virtual Chassis Fabric Deployment on page 72
Autoprovisioning a Virtual Chassis Fabric
Preprovisioning a Virtual Chassis Fabric
Configuring a Nonprovisioned Virtual Chassis Fabric
Connecting a QFX5100 Device to a Network for Out-of-Band Management on page 180
Connecting a QFX5100 Device in a Virtual Chassis Fabric on page 187
Connecting a QFX3500 or QFX3600 Switch in a Virtual Chassis Fabric
Connecting EX Series Switches in a Virtual Chassis Fabric
Adding a Device to a Virtual Chassis Fabric
Chapter 11: Installing the Switch
"Connecting a QFX5100 Device to
180.
"Connecting a QFX5100
187, Connecting a QFX3500 or QFX3600
167