Series - Juniper QFX5100 Hardware Manual

QFX5100 Switch Hardware Guide
Interface Specifications for SFP, SFP+, and QSFP+ Transceivers for the QFX Series
94
This topic describes the specifications for the SFP, SFP+, and QSFP+ transceivers used
in QFX Series devices.
NOTE: This topic does not describe which devices support these transceivers.
For information about which transceivers are supported on QFX Series devices,
see the Hardware Compatibility Tool
Interface Support for the QFX3600 Device
Interface Support for the QFX3500 Device
Interface Support for the QFX5100 Device on page 86
Interface Support for the QFX3008-I Interconnect Device
The optical transceivers installed in QFX Series devices support digital optical monitoring
(DOM): you can view the diagnostic details for these transceivers by issuing the operational
mode CLI command
show interfaces diagnostics optics
output for copper transceivers or transceivers not purchased from Juniper Networks.
The three tables in this topic describe the optical interface support over single-mode
fiber-optic (SMF) and multimode fiber-optic (MMF) cables and copper interface support
over four-pair, Category 5 shielded twisted-pair cables:
Table 37 on page 95—Copper interface support and optical interface support for
Gigabit Ethernet SFP transceivers.
Table 38 on page 100—Optical interface support for 10-Gigabit Ethernet SFP+
transceivers.
Table 39 on page 113—Optical interface support for 40-Gigabit Ethernet QSFP+
transceivers.
NOTE: If you are using the QFX-QSFP-40G-ESR4 transceiver in an access
port and have configured the port to operate as multiple 10-Gigabit Ethernet
interfaces, you can use a fiber breakout cable to distribute the interfaces
to up to four 10GBASE-SR SFP+ transceivers. Juniper Networks does not
sell fiber breakout cables.
or the following topics:
. The command does not give any
Copyright © 2016, Juniper Networks, Inc.