Interface Alarm Messages - Juniper QFX5100 Hardware Manual

QFX5100 Switch Hardware Guide
Related
Documentation

Interface Alarm Messages

Related
Documentation
234
Chassis Alarm Messages on a QFX3008-I Interconnect Device
Chassis Alarm Messages on a QFX3500 Device
Interface Alarm Messages on page 234
show chassis alarms
show system alarms
Interface alarms are alarms that you configure to alert you when an interface is down.
To configure an interface link-down condition to trigger a red or yellow alarm, or to
configure the link-down condition to be ignored, use the
] hierarchy level. You can specify the
chassis
management-ethernet interface type.
NOTE: Fibre Channel alarms are only valid on QFX3500 devices.
NOTE: When red alarms or major alarms are issued on QFX5100 and EX4600
switches, the alarm LED glows amber instead of red.
By default, major alarms are configured for interface link-down conditions on the control
plane and management network interfaces in a QFabric system. The link-down alarms
indicate that connectivity to the control plane network is down. You can configure these
alarms to be ignored using the
NOTE: If you configure a yellow alarm on the QFX3008-I Interconnect device,
it will be handled as a red alarm.
Understanding Alarms on page 233
alarm
,
ethernet fibre-channel
statement at the [
alarm edit chassis
Copyright © 2016, Juniper Networks, Inc.
statement at the [
edit
, or
] hierarchy level.